Tuned Yota · Independent Authorized AMSOIL Dealer · Lakeville, Minnesota, USA · This website is owned and operated by an independent AMSOIL Dealer and is not AMSOIL INC.

Tuned Yota FluidsIndependent Authorized AMSOIL Dealer

Service Guide · Toyota Land Cruiser 1998 · 4.7L V8 (2UZ-FE)

1998 Land Cruiser 4.7L Oil Capacity (7.2 qt) and Oil and Filter Change

The 1998 Land Cruiser 4.7L V8 takes SAE 5W-30 and 7.2 US quarts with the filter, 6.8 without. The drain plug goes back with a new gasket at 39 N·m, and the filter goes on hand-tight until the gasket touches, then 3/4 of a turn. Set the level warm, five minutes after shutdown, and never above the full mark. Every figure below is from the Toyota repair manual for the 1998 truck; we have not checked later model years, so see the note at the bottom before you use this on a different year.

Safety. Required: safety glasses, gloves, and the truck level on a lift or on jack stands with the wheels chocked. Recommended: a drain pan and a torque wrench. Toyota's own caution on this job: used engine oil contains potentially harmful contaminants, so wear protective clothing and gloves that oil cannot penetrate, and wash with soap and water, never gasoline, thinners or solvents. Dispose of used oil and used filters only at designated disposal sites.

The numbers

Oil gradeAPI grade SH Energy-Conserving II or SJ Energy-Conserving, or ILSAC multigrade engine oil, SAE 5W-30. Toyota calls 5W-30 the best choice for fuel economy and cold starts.
Capacity, with filter7.2 US qt (6.8 L)
Capacity, without filter6.8 US qt (6.4 L)
Capacity, dry fill8.5 US qt (8.0 L)
Oil pan drain plug39 N·m, new gasket. The procedure prints 29 ft-lb; the specification table prints 25 ft-lb for the same 39 N·m (39 N·m converts to about 29 ft-lb).
Oil filterHand-tight until the gasket seats, then 3/4 turn with SST 09228-07501. The manual gives no torque for the filter.
Level checkWarm the engine, stop it, wait 5 minutes, then read the dipstick between L and F
Labor time (manual)1.0 hour for lube and filter service

Parts and fluid

PositionProductNote
Engine oil · SAE 5W-30AMSOIL Signature Series 5W-30 100% Synthetic Motor OilTakes 7.2 qt with the filter, so order 8. AMSOIL's lookup lists this oil for the 2006-2007 Land Cruiser 4.7L; confirm it for your year.Buy on AMSOIL.com
Oil filter · AMSOIL EaAMSOIL Ea Oil Filter EA15K51AMSOIL lists this filter for the 2006-2007 Land Cruiser 4.7L. Confirm fitment for your year; the 1998 manual does not print a filter part number we can quote.Buy on AMSOIL.com
Gasket · Toyota dealerOil pan drain plug gasketToyota's procedure installs the drain plug with a new gasket every time

Tools

Procedure

  1. Get the truck level and open the underside. Park level, on a lift or on jack stands with the wheels chocked. Remove the 2 nuts and engine under cover No. 3.
  2. Drain the oil. Remove the oil filler cap first, so the pan drains freely. Remove the oil drain plug and drain the oil into a container.
  3. Remove the filter. Remove the 2 bolts and the service hole cover. Use SST 09228-07501 to remove the oil filter. Clean the contact surface on the oil filter mounting.
  4. Fit the new filter. Lubricate the filter's rubber gasket with clean engine oil. Tighten the filter by hand until the gasket contacts the seat of the filter mounting. Then use the SST to give it an additional 3/4 turn to seat the filter.
  5. Refit the drain plug. Clean the drain plug and install it with a new gasket, torqued to 39 N·m (about 29 ft-lb).
  6. Fill the engine. Fill with new SAE 5W-30. A drain and refill with a filter change takes 7.2 US quarts (6.8 L). Reinstall the oil filler cap.
  7. Check for leaks and set the level. Start the engine and check for leaks at the drain plug and the filter. Then recheck the level: warm the engine, stop it, wait 5 minutes, and read the dipstick, which should sit between L and F. If it is low, check for leakage and add oil up to the F mark. Toyota's instruction is explicit: do not fill engine oil above the F mark.
  8. Close up. Reinstall engine under cover No. 3 and the service hole cover. The manual gives no torque for these fasteners, so snug them without overtightening.

Grade, capacities, torques and procedure are from the Toyota repair manual for the 1998 Land Cruiser AWD 4.7L V8 (2UZ-FE). That manual covers one model year, and 1998 is not a year Tuned Yota calibrates (our 4.7L Land Cruiser coverage is 2006-2007). The 100-series Land Cruiser was built over several years, and we have not verified these figures for other years, so confirm the specification for your exact year and torque to spec. The drain-plug ft-lb figure is printed two different ways in that manual (see above). AMSOIL's coverage of this application is AMSOIL's published claim. Tuned Yota is an Independent Authorized AMSOIL Dealer; every Buy link opens the product on amsoil.com.

Frequently asked questions

What oil does a 1998 Land Cruiser 4.7L take?
SAE 5W-30. The Toyota repair manual specifies API grade SH Energy-Conserving II or SJ Energy-Conserving, or ILSAC multigrade engine oil, and says SAE 5W-30 is the best choice for good fuel economy and good starting in cold weather.
How many quarts does it take?
7.2 US quarts (6.8 L) with an oil filter change, and 6.8 US quarts (6.4 L) without. Dry fill, an empty engine, is 8.5 US quarts (8.0 L). Order 8 quarts for a filter change.
What torque does the drain plug take?
39 N·m, with a new gasket. The manual disagrees with itself on the imperial figure: the procedure says 29 ft-lb and the specification table says 25 ft-lb. 39 N·m is about 29 ft-lb, so the procedure's figure is the one that matches the metric value.
How tight does the oil filter go?
By hand until the rubber gasket touches the seat, then another 3/4 turn with the filter wrench (Toyota SST 09228-07501). Toyota prints no torque value for the filter.
How do I check the level correctly?
Warm the engine, stop it, and wait five minutes before reading the dipstick. The level should sit between L and F. Toyota's manual states plainly: do not fill with engine oil above the F mark.
Is the GX 470 the same?
Do not assume so. The 2003 Lexus GX 470 uses the same 2UZ-FE engine, but its manual prints 6.2 L (6.5 US qt) with the filter, against 6.8 L (7.2 US qt) in the 1998 Land Cruiser manual. Its drain-plug torque (39 N·m) and filter procedure match, but the capacity does not. Use the manual for your own truck.